Description
The Sagola 4600 HEX is a lightweight, gravity-feed refinishing gun engineered for fast color lay-down and glass-level clear coats.
Its HEX system™ fluid nozzle pre-atomizes material to deliver a flat, balanced fan with uniform droplet size—so you hit target film builds with fewer passes, less mottling, and minimal texture.
Built from anodized aluminum with stainless wetted parts and PTFE seals, it’s made for daily booth work in automotive and industrial shops.
Add Essentials
$148.00
Air Caps | Sagola 4600
Configure how you spray in 20+ different ways. Each air cap can be used on...
$129.50
Air Caps | Sagola 4600 Xtreme
Configure how you spray in 20+ different ways. Each air cap can be used on...
$135.00
Needle Nozzle Kit | Sagola 4600
Change your flow rate with the 4600 needle & nozzle kit. This kit will work...
$30.00
Sagola Disposable Paint Cup Adapters
Use the Sagola Disposable Paint Cup system with every spray gun in your arsenal. These...
$29.00
Cup Adapter | Sagola 4600
Use the best paint cup for you with our wide selection of couplings. Easily interchange...
Sagola 4600 HEX Spray Gun
Base / 1.20mmGet notified when this item is back in stock
Press & drag to view
Why Pros Pick It
HEX system™ nozzle
star-geometry pre-atomization for finer spray at higher flow rates—better coverage, smoother blends, truer color.
Dialed-in control
independent product, air, and fan regulators; run low pressures without starving the pattern.
Real-world speed
wide, stable fan reduces overlap corrections and rework.
Built to last
anodized body, stainless internals, solvent-resistant seals.
Clean-air ready
pairs best with coalescing filtration; antistatic hoses recommended in ATEX zones.
Ideal Uses
Automotive refinish (basecoat, clear, waterborne)
Industrial coatings on metal, wood, plastics
Adhesives and varnishes needing consistent film builds
Aircaps, Tips & Needles
- Aircaps: DVR BASE, DVR CLEAR, DVR CLEAR PRO, DVR HVLP
- Tip/needle sets: 1.20, 1.20 XL, 1.30 (swap in minutes)
- Air consumption (ref): DVR HVLP ~425 L/min; DVR BASE ~290 L/min (at stated test pressures)
Compliance & Approvals (USA)
- SCAQMD Rule 1151 compliant: when used with Sagola RC1 analog gauge (200100036) or Sagola digital gauge (559018).
- ATEX: II 2G T4 X (use earthing/antistatic hoses in explosive atmospheres).
Pro Setup Tips
- Start at ~2.0 bar inlet, fan wide open; trim pressure to the lowest that achieves your finish.
- Keep perpendicular travel and consistent gun speed to maximize transfer and avoid dry spray.
- For waterborne or hot/dry booths, step up tip size +0.1–0.2 mm and slightly round the fan to load the core.
FAQs
What pressures should I run?
General work: 1.4–2.2 bar (20.3–31.9 psi). HVLP reference: ~1.8 bar (26 psi). Never exceed 4 bar max.
Which tip for base vs. clear?
Common picks: 1.20 / 1.20 XL for base & waterborne; 1.30 for higher-build clear. Match to product viscosity and booth conditions.
How do I keep it in spec?
Clean after each use, lightly lubricate moving threads, and use OEM parts. Solvent-resistant internals; avoid halogenated solvents. Warranty: 3 years.